FD 340Document FolderOPERATOR MANUAL SECOND EDITION2/08
6CROSS FOLDINGCross folding refers to folding a document in one pass and then running it through the folder a second time to be folded again.Tab “B”Ta
Thicker paper from 28 # up to 65 # may require special stacker wheel setup moving the stacker wheels closer than the position “A” slot. If stacking i
OPERATOR MAINTENANCE1. It is recommended to let forms cool for one-half hour, from the laser printer, before folding. This allows toner to set on th
TROUBLE-SHOOTINGTROUBLEPOSSIBLE CAUSEREMEDYControl panel lights are not illuminated.No power at the wall outlet.No power to the machine inlet.No power
TABLE OF CONTENTSSUBJECTPAGEDESCRIPTION1SPECIFICATIONS 1UNPACKING 1SETUP 2CONTROL PANEL 2OPERATION 3SETTING CUSTOM FOLDS 4BATCH COUNTING4MULTI-SHEET
DESCRIPTIONFUNCTIONThe FD 340 Folder is designed to perform a wide variety of folds using a variety of paper weights. The fold plates are manually adj
SETUP1. Install upper and lower fold plates in position. Be sure the plates are set fi rmly on the locating pins (Fig 1a & 1b). Slide the fold pla
OPERATION1. Place power switch in the “ON” position.2. To set the fold plate stop position, squeeze the stop plate lever and move the stop plate to
SETTING CUSTOM FOLDSBATCH COUNTINGThe batch counter can be set from “0” to “999”. Press the “Batch Counting” button to illuminate the “Batch Counting”
5MULTI-SHEET FEEDING (OPTIONAL)MULTI-SHEET FEEDING (OPTIONAL)The multi-sheet feeder is designed to fold pre-collated stapled or unstapled sets of pape
Comentarios a estos manuales