Formax FD 332 Manual de usuario

1 FORMAX FD 332 Document Folder âOperator Manual First Edition

10Set the paper guide for the appropriate paper size. Neatly stack the paper on the feed table with its printed side facing up. (its printed side d

11 Switching the Power on: Insert the power plug into the outlet. Set the POWER to ON position. Note: Remove the power plug from the outlet after

12Fold Feed Angle/Skew Adjustment: Turn the feed angle adjustment knob to the right if the lower side of the folded paper slants to the right. Tu

13 Press the appropriate numerical key to select the number of forms to be folded. Example: press the number “10” key twice to select twenty. Not

14Should a paper jam occur, set the POWER to the OFF position immediately and remove the jammed sheets. When the jammed paper is stuck around the fo

15Note: The maximum weight of paper that can be used for cross folding is 28#. This requirement, however, varies according to the following condi

16Long Letter fold Short Long Zigzag fold Short Long Double parallel fold Short Long Fold-out Short Fine Adjustments for Table 2 Fold ty

17 Short Long Letter fold Short Long Zigzag fold Short Long Double parallel fold Short Long Fold-out Short (4) Daily Maintenance 1 B

184 If paper chips, ink, etc. are accumulated on the paper feed rubber roller and the paper separator, paper feed performance deteriorates and the m

19 (5) Trouble Shooting Trouble Possible Cause Measures Paper sticks just after it is printed Jog the paper sufficiently or feed the paper after it

2

20The surface of four fold rollers are stained with paper chips or ink (slippery situation) Clean away the stain on four fold rollers using the appro

3 Introduction Thank you very much for purchasing the FD 332 Document Folder. This machine enables users to achieve greater efficiency at work by r

4 (1) Specifications Model FD332 Paper size 3.5” x 5.0” to 11” x 17” Smaller size is for single fold only. Paper quality High-quality paper, high

5Additional functions: Skew adjustment memory, paper jam detector, four-digit counter with addition/subtraction modes, and automatic paper size detec

6 (3) Description of Parts

7 Number Name Number Name 1 Roller cover 10 Table 1 2 Left side cover 11 Control panel 3 Paper feed roller 12 Paper feed table 4 Paper g

8 No. Designation/Indication Function 1 Test key Test folding of two sheets is performed. 2 Start/Stop key Operation starts and if pushed again,

9 (5)Preparation Install Table 1 and 2: Insert Table 1 on the studs indicated by (a) and (b) as shown in the picture to the right. Insert Tabl